Sydney Based Plumber Service: Best Options


 

The best way to quickly remove a clog from a toilet is to use the flange plunger that is most conveniently placed. But what should you do if you can't get to a plunger and your toilet gets clogged? Perhaps you've recently relocated to a new home. You could be at a friend's house that doesn't have a plunger. Is there anything more you can do than use a plunger to clear a clogged toilet?

In case you were wondering, clearing a clogged toilet without a plunger isn't nearly as difficult (or unpleasant) as you might think. Even the most stubborn clogs can be removed without resorting to a plunger by following one of several surprisingly simple procedures. Here are some of the most common ways to clear a clogged toilet, along with the recommended sequence in which to try them.

Cleaning a blocked toilet with hot water is the most efficient method

Start by heating up a large bucketful of water to a rolling boil. Take note that you want it warm, but not scalding. There is a risk that the porcelain used to make the bowl will break if water is brought to a rolling boil in it. You can skip buying this and instead fill a bucket with water from your hottest faucet. After filling the toilet bowl with hot water almost to the top, you should leave it alone for a while.

The toilet should be able to flush away any solid waste after it has been broken down by the heat. If at first you don't succeed, try, try again; there's no reason to panic. The "hot water toilet method" is only the first step in a longer process. You can give this work from plumber Sydney west.

You can use dish soap to clear a clogged toilet

Scrub the toilet bowl with a lot of dish soap. Use a product like Dawn that can effectively cut through grease. Allow it to settle for about fifteen minutes. In the event that there are particles present, the soap will dissolve them. The lubrication it provides to the pipes and bowl will also aid in the clog's descent into the drain.

It is recommended to repeat the "hot water technique" after using dish soap in the toilet. Wait another half an hour or so after adding a pot of hot (but not boiling!) water to the bowl.

After allowing the water and soap some time to work their way through the blockage, try flushing the toilet one more time. If the issue persists, you can try this again or you can leave the dish soap in the toilet bowl overnight.

Epsom salt can be used to unclog a toilet

A pleasant surprise awaits you if you happen to have any Epsom salt on hand. Epsom salt causes a chemical reaction in water, leading to bubbling and fizzing. The continuous gurgling and bubbling could prove very useful in clearing clogged drains.

The plumber Sydney west should fill the toilet bowl with Epsom salt until it is at least an inch from the top. Don't flush the toilet for at least 15 minutes. Positive results should become apparent after the initial treatment cycle. Add another layer of defense by combining this method with the "hot water technique," which also makes use of dish soap.

Comments

Popular posts from this blog

The Importance of Personalized Tutoring in Sydney

Top Reasons Why Meeting Room Brisbane is Perfect for Your Next Business Gathering

Snap Fitness Mount Druitt: Your Ultimate Gym Destination